Skip to main content
Blog

DIY Pergola Kit

By May 27, 2014March 26th, 2020No Comments

DIY pergola kit
Here are a few pictures we were sent by a customer of ours Neil Teasdale. He ordered his pergola kit through our online quoting tool, and was kind enough to take a number of photos throughout the process so that we are able to show a number of the steps he went through in building his pergola.
He also sent us a testimonial which I’ve attached below.

Pre cut timber for Gable Pergola
Pre cut timber for Gable Pergola
Slot cut into fascia for rafter stiffeners
Slot cut into fascia for rafter stiffeners
Rafter stiffeners fastened to house rafters
Rafter stiffeners fastened to house rafters
Fascia brackets installed
Fascia brackets installed
Fascia Beam installed
Fascia Beam installed
Beams fixed in place
Beams fixed in place
Gable frames assembled
Gable frames assembled
One gable frame in place
One gable frame in place
Gable frames in place, ridge about to be lifted into place
Gable frames in place, ridge about to be lifted into place
Ridge installed.
Ridge installed.
Purlins in place from above. Framework completed.
Purlins in place from above. Framework completed.
Roofing and gable end installed
Roofing and gable end installed
View from inside the pergola
View from inside the pergola
View from above. Job Done!
View from above. Job Done!
 
Dear Jakuf
I would just like to take this opportunity to thank you and the staff at Softwoods for the help in making my DIY Verandah project into a complete success. From using your online quote tool to the end of the project I could not have asked for better support.
As I work fulltime and only have weekends free I found it invaluable that you organised drawings and council approval, which were through in a matter of days. As this was the first project of its type I had undertaken I was also impressed not only with the instructions that came with the kit but the kit itself, everything was cut accurately and  all hardware  came with it, even the concrete for the posts which I had not taken into consideration.
As a do it yourselfer, I suppose the most challenging part of the  installation was  that of the rafter stiffeners but after A good read of the instructions and a little patience I completed the work easily. I am forwarding some pictures of the job and am happy for you to use them as you see fit. Once again, thanks for all your help, it was not only satisfying to complete the job myself I also saved myself thousands in the process.
P.S. The roof is getting a clean too.
Regards
Neil Teasdale​